Power Supply; Configuration Of The Dante Network; Installing The "Dante Controller - Monacor WALL-05DT Mode D'emploi

4.2 Power supply

Power supply can be made via the network connection (Power over
Ethernet): Connect the jack IN / PoE (5) to a network connection pro-
viding PoE (e . g . PoE switch) . For a higher output power, connect an
additional power supply . If power supply via PoE is not possible or if
the maximum output power is required, use a DC power connector
with the dimensions 5 .5 / 2 .1 mm (outside / inside diameter) to connect
a regulated 12 V DC power supply unit with a permanent rating of 2 A
to the jack 12 V ⎓ (7) . Observe the correct polarity: inside contact = + .
A suitable power supply unit is, for example, PSS-1230DC from
MONACOR .
36

5 Configuration of the Dante Network

WALL-05DT is configured as a receiver in the Dante network by means
of the program "Dante Controller", available as a free download on
the website of the company Audinate . The settings made via the pro-
gram will be saved in the corresponding transmitters and receivers of
the Dante network so that the program is only required for network
configuration but not for normal operation . The following system
requirements apply to the computer on which the program "Dante
Controller" is to be executed:
Component
Processor 1 GHz
RAM 512 MBytes
Standard Ethernet interface (100 Mbits / s or Gigabit) or
Network
wireless LAN (WiFi) interface
Windows 7 (SP1 or higher), 8.1 or 10
Note: Both UTF-8 and Unicode will be supported, except for host names
and names of units; the DNS standard will not support Unicode for them.
Operating system
Mac OS X 10.9.5, 10.10.5 or 10.11
Note: Intel architecture only; PPC architecture will not be supported.
Fig. 3 System requirements for "Dante Controller"
Windows is a registered trademark of Microsoft Corporation in the USA and other
countries. Mac OS is a registered trademark of Apple Computer, Inc. in the USA
and other countries.

5.1 Installing the "Dante Controller"

To install the program from the Audinate website:
1) Call up the following Internet address:
https://www .audinate .com/products/software/dante-controller
2) Select the operating system .
3) Click the button with the version of the Dante controller .
Minimum requirements