MALONE Stax Pro2 Instructions D'installation page 5

Installation & Loading Instructions - MPG115MD Stax Pro2
8 8
. Apply a t-knob to the bolt and slightly
tighten until the carrier is secure on
the cross bar. Repeat for the second
carrier and rear cross bar. See image 9.
10
10
Step 3: Loading the Kayaks
Place the kayak(s) bottom down on the
. Route the free end of a 12' load strap
crossbars and foam pads. See image 11.
through one strap slot in the top of the
carrier. Pull the free end back until
there is an even loop. Repeat for the
second carrier. See image 11.
MALONE
. Insert a mounting bolt into the rear side
. Raise the carriers to the up-position and
hex hole and down through the Jawz
mounting adapter. See image 8.
9
9
confirm alignment. Tighten the t-knobs
until both carriers are securely fixed to the
cross bars. Place foam blocks onto the cross
bars and next to the carriers. See image 10.
Note: When transporting one kayak; the
carriers should be positioned so that the
distance from the carriers to the cross bar
towers is exactly the width of the kayak.
11
11
R
TM