MALONE Stax Pro2 Instructions D'installation page 4

Installation & Loading Instructions - MPG115MD Stax Pro2
4
4
. Loosen the tightening knob and place
the carrier into the fold-down position.
Insert a mounting bolt into the forward
side hex hole. See image 5.
6
6
Raise the carrier into the upright
position. Place the carrier onto the
. Raise the carrier into the upright
front cross bar so it folds towards the
position. Place the carrier onto the
rear of the vehicle. Swing the Jawz
front cross bar with the oval side of
under the cross bar as shown.
See image 7
the carrier facing the front of the
vehicle. Swing the Jawz under the
Note: The base of the carrier has a rectangular "cutout" that
cross bar as shown. See image 7.
has been included for square cross bar fit. This "cutout" does
not effect the fit or function of the carriers when installed to
round or oval shaped cross bars.
MALONE
. Install a black round tightening knob onto
Step 2: Installing Carriers to the Cross Bars
. Insert a mounting bolt through one hole of
the exposed end of the bolt. See image 4.
5
5
a Jawz mounting adapter and loosely apply
a t-knob. See image 6.
7
7
R
TM