Start Up Behavior - Cooper Lighting Solutions SVPD Serie Mode D'emploi

Installation Instruction Supplement - Luminaire with Ambient Integrated Sensor
INSTALLATION
Fixture Installation/Wiring with Integrated
Sensor
1. Follow all installation and wiring instructions found
on the installation instructions for the luminaire. See
www.cooperlighting.com for additional information.
2. Install all luminaires in the same area with the integrated
sensor in the same orientation, or as indicated on the
lighting plan.
NOTE: Installation of integrated sensors within 3-ft (1m)
of HVAC air vents is not recommended.
3. The integrated sensor is factory wired to the luminaire,
and does not require additional field wiring other than
power.
4. Remove all luminaire and sensor protective covers after
installation and prior to using the integrated sensor
system.
5. Refer to this guide for additional information
regarding integrated sensor systems offered.
For additional information on a system, refer to
www.cooperlighting.com.

Start Up Behavior

SVPD1, SVPD2, SVPD3, SVP3 Sensors
1 Turn power ON to the fixture.
2 The light will start at 50% light level and
then raise or lower to the daylight level.
3 The sensor RED LED should slow blink
(ON for 2 seconds, OFF for 2 seconds)
for a 1 minute duration then blink only on
occupancy.
4 Wait for next daylight adjustment/
occupancy action.
5 System is fully operational.
2
Installation instructions Supplement - Luminaire with Ambient Integrated Sensor
ADF14295 V01 www.cooperlighting.com
Start Up Behavior
WaveLinx Lite series - WAB Sensor
1 Turn power ON to the fixture.
2 If occupied, the fixture will go to 100%.
The occupancy is set for High sensitivity.
3 The sensor GREEN LED will flash for
100ms once every 3 seconds when
motion is detected.
4 The fixture will dim to 30% after 10
minutes when the space is unoccupied.
The fixture will dim to OFF after 10
additional minutes if the space is still
unoccupied.
5 Ready for system configuration in the
WaveLinx Lite mobile app. See online
information for details at
www.cooperlighting.com.
WaveLinx series - WAA, WLA Sensors
1 Turn power ON to the fixture.
2 The light will start at full, then change to
auto-ON to 75% light level.
3 The sensor GREEN LED will remain ON
until the integrated sensor is paired with
a compatible WaveLinx system.
4 The light with integrated sensor will
remain on until the occupancy timeout
(20 minutes) is reached, and will
automatically turn OFF. Daylighting is
disabled until configured.
5 Ready for system configuration in the
WaveLinx mobile app. See online
information for details at
www.cooperlighting.com.