Angelcare AC1320 Manuel Du Propriétaire page 8

4.1 - SOUND
TO ACTIVATE SOUND:
1
2
TO TEST THE SOUND:
Ask someone to speak into the Nursery Unit or place
the unit near a radio to ensure that sound is being picked up.
IF YOU HEAR NO SOUND: TO ACTIVATE SOUND:
• Check that both units are powered ON.
• Check that both units are plugged into functioning electrical outlets.
• Check the batteries in both units (replace or recharge them if necessary).
• Bring the Parent Unit closer to the Nursery Unit.
ADJUST SOUND LEVEL
4.2 - BATTERIES
HOW TO CHECK THE BATTERIES:
Unplug the adapters from both units.
• If the green light on the Nursery Unit
does not show, replace the batteries.
• If the Parent Unit and its screen do not
light up, recharge the batteries.
HOW TO CHARGE THE BATTERIES IN THE
PARENT UNIT:
Leave the Parent Unit plugged to fully charge the
unit. Although the batteries at 1/3 capacity works
normally, we recommend that you fully recharge
them.
IMPORTANT
• Test your monitor before first use.
• Test your monitor regularly to ensure it is functioning correctly.
8
01mf6_Manuel_AC1320_INT_12320.indd 8
All manuals and user guides at all-guides.com
1) Press Menu/Select button to access
3
2) Select the Sound icon and press Menu/
4 3) Use the up and down arrows to activate
4) Press Menu/Select button to confirm.
Increase volume
(Up arrow)
Lower volume
(Down arrow)
main menu.
Select button again.
or deactivate the sound.
IMPORTANT
To avoid feedback (whistling), keep both units
at least 3 meters apart.
PUT IN SILENT/MUTE MODE
Press the down arrow
for 2 seconds to mute
sound. Mute icon will
flash. Press again for 2
seconds to reactivate
sound.
1/3 full
PARENT UNIT BATTERY ALARM
• Alarm activates when the batteries need to
be recharged.
• Parent Unit will emit a beep sound every 15
seconds.
• Empty Battery icon will show on LCD
screen.
2/3 full
full
2016-02-17 3:06 PM