Care And Cleaning; General Cleaning; Routine Cleaning - Hamilton Beach FlexBrew Mode D'emploi

Care and Cleaning

w WARNING Shock Hazard.
Do not immerse cord, plug, or coffee maker in any liquid.
Cut Hazard.
w CAUTION
Removable single-serve pack holder has a sharp needle. Piercing
needle on underside of lid also is sharp. Use caution when handling.

General Cleaning

1. Unplug and allow to cool.
2. Hand-wash all removable parts in hot, soapy water. Rinse and dry
or wash in TOP RACK only of dishwasher. DO NOT use "SANI"
setting when washing in dishwasher. "SANI" cycle temperatures
could damage your product.
3. Wipe outside of coffee maker with a soft damp cloth.

Routine Cleaning

All coffee makers should be cleaned at least once a month (once a
week for areas with hard water).
1. Plug into outlet.
2. Pour 3/4 cup (177 ml) of plain white vinegar and 3/4 cup (177 ml)
of cold water into reservoir.
3. Place a 14-oz. (414-ml) or larger cup or travel mug underneath
to catch water/vinegar solution. Press BREW REG or BREW BOLD
button once. When solution starts dispensing, press BREW REG
or BREW BOLD button again to stop brewing and allow vinegar to
clean. After 30 minutes, press BREW REG or BREW BOLD button and
allow it to finish brew cycle. When brew cycle is finished, empty
cup and rinse. Run 2 to 3 cycles of cold tap water. The unit is
cleaned and ready to brew coffee.
4. Unplug.
6
Clogged Needle
1. Unplug and allow to cool.
2. Remove gray removable needle holder
in lid by turning arrow from locked icon
( ) to the unlocked icon ( ).
3. Bend a small paper clip. Insert tip of
paper clip through hole of the piercing
needle and up into shaft of piercing
needle to ensure grounds have been
removed.
4. To replace gray removable needle
holder, insert tab between lock icon ( )
and unlock icon ( ) and turn to right to
lock.
2