Connecting Peripheral Equipment; Video Recorder; Other Equipment; Amplifier - Philips 21PT4457/58 Mode D'emploi

Connecting peripheral equipment

Depending on the versions, the TV set will be equipped with 1 or 2 SCART connectors EXT1 and
EXT2 located on the rear. The EXT1 socket has audio, CVBS/RGB inputs and audio, CVBS outputs.The EXT2
socket (if available) has audio, CVBS/S-VHS inputs and audio, CVBS outputs.

Video recorder

VCR

Other equipment

Amplifier

(only available on certain versions)
Front panel connectors
4 5 6
7 8 9
ù
Y 0
Carry out the connections shown opposite, using a good
quality euroconnector cable.
If your video recorder does not have a euroconnector socket, the
only connection possible is via the aerial cable.You will therefore
EXT 2 need to tune in your video recorder's test signal and assign it
EXT 1
programme number 0 (refer to manual store, p. 6).
To reproduce the video recorder picture, press
Video recorder with decoder
Connect the decoder to the second euroconnector socket
of the video recorder.You will then be able to record
scrambled transmissions.
Satellite receiver, decoder, CDV, games, etc.
For TV sets with 2 SCART connectors, preferably connect
the equipment delivering RGB signals (digital decoders, DVD
players, games consoles, etc.) to EXT1 and the equipment
EXT 2
EXT 1 delivering S-VHS signals (S-VHS and Hi-8 VCRs) to EXT2.
To connect to a hi-fi system, use an audio connection cable
and connect the "L" and "R" outputs on the TV set to the
EXT 2 "AUDIO IN" "L" and "R" input on your hi-fi amplifier.
L
EXT 1
R
(only available on certain versions)
Depending on the versions, the connectors are located on
the front (sometimes under a flap) or on the right-hand
side of the TV set. Make the connections as shown
opposite.With the
For a monophonic device, connect the audio signal to the
AUDIO L input. Use the
left and right speakers of the TV set.
Headphones
When headphones are connected, the sound on the TV set will
be cut.The
The headphone impedance must be between 32 and 600 Ohms.

To select connected equipment

n
Press the key to select EXT1 and on the versions with 2 scarts,
EXT2, S-VHS2 (S-VHS signals from the EXT2 socket) and AV for
the side connections (if available).
Most equipment (decoder, video recorder) carries out the switching itself.
n
key, select AV.
e
key to reproduce the sound on the
@ #
P keys are used to adjust the volume level.
0
.
9