Connecting Peripheral Equipment; Video Recorder; Other Equipment; To Select Connected Equipment - Philips 14PT1501 Mode D'emploi

Connecting peripheral equipment

Video recorder

Other equipment

Front panel connectors
0
Telra_12536-951 1-6 (GB)_130106.10 10
Carry out the connections shown opposite, using a good
quality euroconnector cable.
If your video recorder does not have a euroconnector socket, the only
connection possible is via the aerial cable. You will therefore need
to tune in your video recorder's test signal and assign it programme
number 0 (refer to manual store, p. 6).
To reproduce the video recorder picture, press
Video recorder with decoder
Connect the decoder to the second euroconnector socket of
the video recorder. You will then be able to record scrambled
transmissions.
Satellite receiver, decoder, games, etc.
Make the connections as shown opposite.
(only available on certain versions)
Depending on the versions, the connectors are located on
the front (sometimes under a flap) or on the right-hand
side of the TV set. Make the connections as shown
opposite.With the
Headphones
When headphones are connected, the sound on the TV
set will be cut. The
volume level.
The headphone impedance must be between 32 and 600 Ohms.

To select connected equipment

Press the key to select EXT (and AV) for the side connections.
Most equipment (decoder, video recorder) carries out the switching itself
0
key, select EXT (and AV).
@ " #
keys are used to adjust the
.
1/16/2006 1:54:55 PM