Care And Cleaning - Toto CST646F Manuel D'installation Et D'utilisation

9. Adjust the length of the rods. If the push
button rods are too short (see ill. 7a), the
push buttons will not sit properly and
toilet may short flush. If the push button
rods are too long (see ill. 7b), the push
button may continuously activate the
flush valve.
Correct with the following steps:
1. Loosen the lock nuts counter-clockwise.
2. Turn the rods clockwise to shorten,
counter-clockwise to lengthen (each full
turn is 1mm).
3. Place the lid on the tank to check the
adjustment.
4. When the adjustment is completed,
tighten the lock nut to secure.
10. Turn on the water supply at the angle stop. Check ALL connections for
leaks. Fix as needed.
11. The toilet seat is installed with the seat top mounting hardware. Refer
to the seat installation instruction.
Use a detergent or non-abrasive toilet cleaner and a soft bristled
plastic brush to clean your toilet. To remove hard water stains, use
vinegar or lime dissolving cleaner and a non-scratch scour pad
made for porcelain. Allow a little contact time to allow the cleaner
to dissolve the buildup.
Do not spray cleaner directly onto the button, instead wipe it using
a dampened soft cloth with diluted dishwashing detergent and
dry it with another soft cloth. Do not use bleach or products that
include acid or alkaline detergents in their ingredients. Do not use
metal scrub brushes or steel wool.
NOTICE
DO NOT USE IN-TANK BOWL CLEANERS.
The use of high concentration of chlorine or chlorine-related products can
seriously damage fittings in the tank. This damage can cause leakage and
property damage. TOTO shall not be responsible or liable for any tank fitting
failure or damage caused by the use of in-tank bowl cleaners.
INSTALLATION PROCEDURE

CARE AND CLEANING

ill. 7a
ill. 7b
Clip
Locknut
6
If the rod(s) is too
short, the buttons
are lowered
Push button
assembly
Tank Lid
Flush valve
If the rod(s) is too
long, the buttons
are pushed up
and water may
continue to flow
to toilet bowl.
Clockwise/
counter-clockwise