5. Install the side screws to the
mounting blocks. Cover the
screw head with the provided
screw caps (ill. 4).
6. Connect the water supply hose
(not provided) to the fill valve
(ill. 5).
7. Install the flexible water supply hose
to the angle stop (ill. 5). Make sure
that the hose is free of kinks.
8. On the underside of the tank lid,
remove the 2 rods with lock nuts,
and screw them clockwise to the
push button assembly.
Place the lid on top of the tank,
making sure that the full flush push
button is on the left side (ill 6).
INSTALLATION PROCEDURE
ill. 4
Cap
Side-screw
ill. 5
50 mm radius minimum Make sure there are no kinks
ill. 6
Tank lid
Left
Full
Flush
Left
Full ush
5
Cap
Side-screw
Push buttons
Right
Partial
Flush
Right
Partial ush
Flush valve