Robert Juliat ARAMIS+ Mode D'emploi page 20

Disconnect from the mains before any servicing.
Service only by qualified technician.
CONDENSER.
- Disconnect from the mains.
- Open the lantern's bonnet.
- Take out the lamp.
( Refer to the page 16 and proceed in reverse order).
- Turn the fast lock 1 .
- Withdraw the lens holder 2 .
- Clean the lens 3 with a soft dry cloth.
- Remount parts in reverse order.
- Clean in the same way, the 2 lenses found in the zoom.
REFLECTOR.
- Disconnect from the mains.
- Open the lantern's bonnet.
- Take out the lamp.
( Refer to the page 16 and proceed in reverse order).
- Clean the reflector 4 with a soft dry cloth.
- Remount parts in reverse order.
SPARK-GAP.
- Disconnect from the mains.
- Open the lantern's bonnet.
- Unsrew the nut a , while holding in place the counter-nut b .
- Then, unscrew the counter-nut b .
- Adjust, with a 2,5 Allen key, the upper electrode c to
1 mm from the electrode.
- Tighten the counter-nut b and the nut a .
• The adjustment is made, when manufactured.
Interfere only in case of a faulty starting.
20
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr
All manuals and user guides at all-guides.com
TECHNICAL FILE
2500W HMI FOLLOW SPOT
1013+
1013+ B
1013+ BS
VALID SINCE : 30.07.02