American Standard Town Square S TU45550 Serie Instructions D'installation page 2

2
INSTALL VALVE TRIM (STANDARD WALL INSTALLATION)
• Figure 1. Push CAP (1) over VALVE CARTRIDGE (2) until
seated against stop.
• Figure 2. Make sure O-RING (6) is secure within
ESCUTCHEON HOLDER (3). Push ESCUTCHEON
HOLDER (3) onto CAP (1) and attach with LONG SCREWS (4).
• Figure 3. Install ESCUTCHEON (7) onto CAP (1) and push
flush against finished wall. ESCUTCHEON (7) will snap fit
onto ESCUTCHEON HOLDER (5).
Figure 2.
3
INSTALL, TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
Protect finish on SHOWER HEAD
CAUTION
and TUB SPOUT when installing.
Note: Apply sealant or Teflon Tape to shower arm.
• Remove PIPE PLUG and CAP (1, 2) from shower pipe
and tub filler pipe.
• Install SHOWER ESCUTCHEON (3) onto SHOWER ARM
(4). Apply sealant or Teflon tape to threads on both ends
of SHOWER ARM (4) and thread longer leg of SHOWER
ARM (4) into shower elbow.
• Thread SHOWER HEAD (5) onto SHOWER ARM (4).
Install TUB SPOUT (6). Tighten with HEX WRENCH
supplied.
Important: Do not overtighten Set Screw.
1
3
6
4
1-3/4"
PLASTER
GUARD
Figure 1.
1
5
Figure 3.
1
- 2 -
2
3
O-RING
4
5
APPLY SEALANT OR
TEFLON TAPE TO THREADS
2
6
HEX WRENCH
M965964 Rev. 1.1 (3/20)
1
7