American Standard SERIN 2064.451 Instructions D'installation

SERIN
®
WALL MOUNT FAUCET
IN-WALL LAVATORY FITTING
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
To ensure that your installation proceeds smoothly-please
read these instructions carefully before you begin.
ROUGHING-IN DIMENSIONS
8"
(203mm)
CROSS
HANDLE
HOT
1/2" NPT INLETS
2-1/8" D.
(54mm)
Required Tools
Tubing Cutter
1
INSTALL VALVE BODY
Determine where the finished wall location will be. This measurement
is very important! Note: The rough-in measurement from the finished
wall is; 2" minimum and 3" maximum. This is a 1" tolerance. See
rough-in illustration above.
Secure FAUCET BODY (1) to cross brace of wall structure
at required height using two wood screws.
Connect HOT water supply to left VALVE inlet and COLD water
supply to right VALVE inlet. Use pipe sealant or Teflon tape for
all threaded connections. For sweat connections, do not make
sweat connections directly to valve body. Damage to seals and
and valve cartridge may occur.
Turn valves to off position. Turn hot and cold supplies on and
check fitting connections for leaks .
Complete wall construction.
4"
(102mm)
FINISHED
COLD
(51mm) MAX.
2" MAX.
1-1/4" O.D.
(32mm) O.D.
Adjustable Wrench
Channel Locks
Turn off hot and cold water
CAUTION
supplies before beginning.
Installation
Instructions
2064.451
2" MIN.
(51mm)
WALL
2" D.
(52mm)
Plumbers' Putty or
Caulking
WALL STUDS
Certified to comply with ASME A112.18.1M
U.S. Patent No. 5,819,789
M968852 Rev.1.6 (5/19)
3" MAX.
(76mm) MAX.
1"
(25mm)
2" D.
(52mm)
FINISHED
WALL
9-1/4"
(235mm)
Pipe Wrench
Teflon Tape Flat Blade Screwdriver
CROSS BRACE
WOOD SCREWS
1
16"
HOT
COLD