Table des Matières
Publicité
Ex AZM 415 HU
//
Montage- und Anschlussanleitung / Sicherheitszuhaltung
Mounting and wiring instructions / Solenoid interlock
Instructions de montage et de câblage / Dispositif d' interverrouillage de sécurité
Istruzioni di montaggio e collegamento / Elettroserratura di sicurezza
Instruções de montagem e instalação / Chave de segurança com bloqueio
Инструкция по монтажу и подключению / Реле защитной блокировки
English
Application and operation
=
DANGER
Live parts. Electric shock hazard! Protective cover
over contacts must be intact.
=
DANGER
In case of overloaded contacts too high operation
temperatures. Explosion hazard! Risk of burns! For
short-circuit protection, use fuse size 4 A (gG/gN).
- Use device only within the permitted electrical load limits (see
technical data).
- Use device only within the permitted ambient temperature range
(see product label and technical data).
Cleaning
=
DANGER
Live parts. Electric shock hazard! When cleaning:
observe degree of protection IP67/IP64.
- Use a damp cloth to clean devices in hazardous areas. This prevents
electrostatic charge.
- In case of damp cleaning: use water or mild, non-scratching,
non-chafing cleaners.
- Do not use aggressive cleaners or solvents.
Service, maintenance, repair
=
DANGER
Live parts. Electric shock hazard! Do not repair de-
fective or damaged devices. Replace them.
=
DANGER
Explosive atmosphere. Explosion hazard! Risk of
burns! Observe maximum switching cycles.
=
DANGER
Explosive atmosphere. Explosion hazard! Risk of
burns! Do not rebuild or modify the device in
any way.
=
DANGER
Live parts. Electric shock hazard! Explosion haz-
ard! Open device only while it is in zero potential
state.
With careful mounting as described above, only minor maintenance is
necessary. We recommend a regular maintenance as follows:
1. Check switching function.
2. Check for tight installation of the actuator.
3. Check alignment of solenoid interlock and actuator.
4. Removal of dirt.
5. Screw and close cover correctly, tightening torque 0.5 ... 0.6 Nm.
Disposal
- Observe national, local and legal regulations concerning disposal.
- Recycle each material separately.
N.B.
Do not use the device as a mechanical endstop. Any mounting position
is possible. It should be selected in such a way that no coarse dirt can
fall into the used slot. Furthermore, EN 60079-14 has to be applied for
the installation of electrical equipment in explosive areas. Moreover,
the ATEX test certificate and the special conditions therein have to be
observed. The described products have been developed in order to as-
sume safety functions as a part of an entire plant or machine. A com-
plete safety system normally covers sensors, monitoring modules, in-
dicator switches and concepts for safe disconnection. Therefore, a
val-idation according to EN ISO 13849-2 or EN 62061 is necessary.
Furthermore, the Performance Level according to EN ISO 13849-1
and SIL CL Level according to EN 62061 can be lower than the single
level because of the combination of several safety components and
other safety-related devices, e.g. by serial connection of sensors. It is
the responsibility of the manufacturer of a plant or machine to guaran-
tee the correct general function. steute does not assume any liability
for recommendations made or implied by this description. Subject to
technical modifications. New claims for guarantee, warranty or liability
cannot be derived from this document beyond the general terms and
conditions of delivery.
Français
Utilisation des instructions de montage et de câblage
Groupe cible: personnel autorisé et compétent.
Toutes les manipulations décrites dans cette notice d'installation ne
doivent être effectuées que par du personnel formé et autorisé par la
société exploitante.
1. Lire et comprendre les instructions de montage et de câblage.
2. Respecter les règles de sécurité et de prévention des accidents
en vigueur.
3. Installer l'appareil et le mettre en service.
La sélection et l'installation des appareils et leurs intégrations dans
les systèmes de commande exigent une connaissance approfondie
de toutes les lois pertinentes, ainsi que des exigences normatives du
fabricant de la machine.
En cas de doute, la version allemande fait référence.
Volume de livraison
1 appareil, 1 instruction de montage et de câblage, carton.
4 / 24
Publicité
Table des Matières
