Set Sleep Timer; Set The Alarm Timer - Krüger & Matz KM1908 Mode D'emploi

Owner's manual
• If the connected Bluetooth device supports Advanced Audio Distribution Profile
(A2DP), you can listen to the music stored on the device through the player.
• If the external device supports Audio Video Remote Control Profile (AVRCP), you
can use the player's remote control to play music stored on the device.

SET SLEEP TIMER

This unit can switch to standby mode automatically after a set period.
When the unit is turned on, press TIMER/SLEEP button repeatedly to select a preset
period (in minutes):
120 > 90 > 60 > 30 > 15 > 00
• Press the TIMER/SLEEP button to view the remaining time before switch off.
• To deactivate the sleep timer, press TIMER/SLEEP button repeatedly until
[SLEEP 00] is displayed.

SET THE ALARM TIMER

This un
it can be used as an alarm clock. you can select DISc, USB, DAB or TUNER
as alarm source.
1. In standby mode, press and hold the TIMER/SLEEP button until [TIMER SET]
scrolls on the display. Then the hour digits flash.
2. Press / button on the remote control to adjust the hour digits, and then press
the TIMER button on the remote control to confirm, the minute digits will flash
on the display.
3. Press the / buttons on the remote control to adjust the minute digits, and
then press the TIMER/SLEEP button on the remote control to confirm.
4. Press the / buttons on the remote control to select:
• TUNER (to wake to your selected FM Radio Station)
• DAB (to wake to your selected DAB Radio Station)
• DISc (to wake to your Disc music)
• USB (to wake to your USB music)
Press the TIMER/SLEEP button on the remote control to confirm, the display will
show the volume level.
5. Press the / buttons on the remote control to adjust the volume, and then
press the TIMER/SLEEP button on the remote control to confirm. "TMR ON / TMR
OFF" will flash on the display.
6. Press the / buttons to select "TMR ON" or "TMR OFF" to enable the timer or to
disable the time, and then press the TIMER/SLEEP button on the remote control
to confirm.
Press the TIMER/SLEEP button on the remote control to view the alarm settings or
activate the alarm.
Note:
• Each enabled state will be cleared if a button is not pressed within 15 seconds.
47