System Reset; Dab Information Display - Krüger & Matz KM1908 Mode D'emploi

Owner's manual
DRC (Dynamic Range Control)
Dynamic Range Control is an advanced technology that reduces the difference in
volume between stations when switching stations.
1. In DAB mode, press the MENU Button on the remote control and then press the
, buttons to select "DRC". Press the ENTER button to confirm.
2. Press the ,
button to confirm the setting.

System Reset

1. In DAB mode, press the MENU button on the remote control and then press
the , buttons to select "SySTEM". Press the ENTER button on the remote
control to confirm.
2. Press , buttons on the remote control to select "RESET". Press the
button on the remote control to confirm. The display will show "RESET N". Press
the , buttons on the remote control to select "RESET y". Press the ENTER
button on the remote control to confirm. The display will show RESTART and then
WELcOME. The unit will perform a full scan and the display will show "Scan ...".

DAB Information Display

you can view the DAB service information in the following modes. Depending on the DAB
radio station you are tuning to, some information modes may be unavailable. Repeatedly
press the OSD button on the remote control to view the following information.
• DLS
Dynamic label segment is a scrolling message that the broadcaster may include
with their transmissions. The message usually includes information, such as
programme details etc.
Note: DAB – unlike normal radio, groups together several radio stations and
transmits them on one frequency.
• Singal strength
The display will show a slide bar to indicate the signal strength, the stronger the
signal, the longer the bar will be from left to right.
• Programme type
• Ensemble name
A multiplex is a collection of radio stations that are bundled and transmitted
on one frequency. There are national and local multiplexes. Local ones contain
stations that are specific to that area.
• channel number
• Frequency
• Error in signal
A number showing the error rate. If the number is 0, it means the signal
received is error free and the signal strength is strong. If the error rate is high, it
is recommended to reorient the radio aerial or reposition the unit.
• Audio mode
Stereo/Mono
• clock (if not available, the display will show incorrect time)
• Date (if not available, the display will show incorrect date)
buttons to select DRc hIGh, LOW or OFF. Press the ENTER
/PAIR
41