Krüger & Matz KM1908 Mode D'emploi page 33

Owner's manual
CONNECTIONS
caution: Make all connections before plugging the unit into the Ac Power outlet.
Connect Control Cable
connect the control cable connector from the back of the DVD unit to the
CONTROL CABLE jack on the back of the amplifier.
Connect to Speakers
Note:
• For optimal sound, use the supplied speakers only.
• connect only speakers with impedance that is the same or higher than the
supplied speakers. Refer to the Specifications section of this manual.
1. Loosen the left / right speakers connector.
2. Use the speaker cable (included) to connect the speaker port on the left/right speaker.
• Golden harness cable connect to the "+" (red connector) terminal
• Silver harness cable connect to "-" (black connector) terminal
3. Screw the red (+) / black (-) connector to secure the cable.
4. connect the speakers to the SPEAkER OUT (R/L) sockets on the rear of the main
unit.
33