Dab Radio Operation; Presetting Stations Manually; Recalling A Preset Station - Krüger & Matz KM1908 Mode D'emploi

DAB RADIO OPERATION

Caution:
• Make sure that you have correctly connected and fully extended the antenna.
• you can program a maximum of 20 DAB radio stations.
1. Press the
repeatedly to select DAB radio.
2. Press the MENU button on the remote control to display the DAB menu. Press the
buttons to select Full scan. Press the ENTER button to confirm.
Auto Scan
1. Press the MENU button on the remote control to enter the DAB menu. Then
press the ,
the remote control to confirm. The display will show "SCAN..."that indicates the
progress of the scan and the amount of stations that have been found so far.
• Alternatively directly press and hold the PROG button on the remote control
to perform a full scan.
2. Once the scan has finished, the unit will display the total number of stations
have been found and a list of the found stations. All the stations that have been
found will be stored automatically.
To explore the found stations, press the
• Full auto scan will not replace the DAB stations in memory. If you want to
remove all the previously scanned stations, system reset is required.

Presetting Stations Manually

you can store up to 20 of your favourite DAB stations to the memory. This will enable
you to access your favourite stations quickly and easily.
1. To store a preset, you must first be listening to the station that you would like to save.
2. Press the PROG button on the remote control. The display will show "## Empty",
and the preset number will flash.
3. Press the /
preset number.
4. Press the PROG button to confirm your station, the display will show "STORE".

Recalling a Preset Station

1. Once you have saved a station to one of the preset buttons, you can recall it by
pressing the
number.
2. Preset number and station name will show on the display to indicate the preset
station you are listening to.
• The stored stations will be saved into the memory and power off will not
erase it. Storing a new station in a preset location will erase the previously
stored station in that location.
40
button on the unit or the SOURcE button on the remote control
buttons to select the "FULL ScAN". Press the ENTER button on
buttons on the remote control to select your desired station
/ buttons on the remote control to select your desired preset
, buttons to the selected station.
Owner's manual
,