General Operation; Setting The Clock - Krüger & Matz KM1908 Mode D'emploi

GENERAL OPERATION

Powering ON/OFF
When you insert the Ac power cable into a wall outlet, the unit will be in standby mode.
• Press the STANDBy button to switch the unit on.
• Press the STANDBy button to switch the unit back to standby mode.
Disconnect the mains plug from the mains socket if you want to switch the unit off
completely.
If there is no signal input under the DISc, USB, BT (Bluetooth), ARc, hDMI 1, hDMI 2,
COAXIAL, OPTICAL or AUX mode, the unit will automatically switch off within 15 minutes.

SETTING THE CLOCK

Synchronization of the Clock
Note: by default, time is synchronized with RDS.
1. When in STANDBy mode, press and hold the MENU button on the remote
control to synchronise the clock.
2. Press the / buttons on the remote to switch the clock synchronization modes:
• RDS Only synchronize with the RDS radio station.
• OFF Turn off the clock synchronization function, only adjust the clock
manually.
3. Then press the ENTER button on the remote control to confirm.
Manual setting of the clock
1. In STANDBy mode, press and hold cLOck until "cLOck SET" scrolls on the
display.
2. Press the /
flashing, then press the CLOCK or ENTER button on the remote control to
confirm, then the minute digits will flash.
3. Press the / buttons on the remote control to adjust the minute digits while
flashing, then press the CLOCK or ENTER button on the remote control to
confirm.
Note:
• Press the button on the unit or the
12/24 hour format.
• Each activated state will be cleared if any buttons are not pressed within 15
seconds.
SELECT THE CORRECT TV SySTEM
change this setting if the video is not displayed correctly. By default, this setting
matches the most common setting for TVs.
1. Press the SETUP button to access or exit system setup menu.
38
buttons on the remote control to adjust the hour digits while
button on the remote control to select
Owner's manual