LaserLiner SuperPlane-Laser 3D Mode D'emploi page 9

Horizontal and vertical levelling
2
Release the transport restraint, set slide switch (2) to "ON". The horizontal laser line appears.
The laser lines can be switched individually with the selection button.
LASER LASER
The transport restraint must be released for horizontal and vertical levelling. The laser lines flash
!
when the device is outside the automatic levelling range of 3°. Position the device such that it is
within the levelling range.
Hand receiver mode
3
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out levelling at great distances or when the laser lines are no
longer visible. To work with a laser receiver, switch the line laser to hand-held receiver mode by keeping
button 5 (handheld receiver mode on / off) pressed. The laser lines will now pulsate with high frequency,
making the laser lines darker. The laser receiver can detect these pulsating laser lines.
!
Observe the laser receiver's operating instructions for line lasers.
Due to the special optics required to generate a continuous 360° laser line, the underlying
!
technology may cause differences in brightness in different areas of the line. This may lead
to different ranges in hand receiver mode.
Slope mode
4
Do not release the transport restraint, set slide switch (2) to "OFF" and switch on slope mode by pressing
and holding (3 seconds) button 5. Select the laser with the selector button (5). Sloping planes and tilts
can now be measured. In this mode, the laser lines no longer align automatically. This is signalised by the
laser lines flashing.
LASER LASER
LASER LASER
LASER LASER
SuperPlane-Laser 3D
09
EN