Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Connect the microphone with the supplied USB cable
to your PC. When connecting the cable to the micro-
phone, make sure that the USB symbol of the cable
plug points to the top. The supplied USB cable of the
type B is 3 m long. If you need longer cables, you must
use active USB-Repeater cables, which can be
obtained at computer shops. With active extension
cables a maximum length of 20 m is possible; if the
length is more than 20 m, dropouts can occur and the
audio quality can deteriorate.
• Do not use passive extension cables, it might be
possible that the microphone is not recognised as
hardware component by your computer anymore.
• If you connect the microphone to a PC with the
operating system Windows
found automatically as new hardware. A message that
the new hardware has been installed and is now ready
for use will be displayed.
• Now before you can use the microphone for recordings
you must select the correct device for sound recording
and the recording level.
• Select the Start button, Settings and Control panel.
Under Control panel open the menu item Sounds
and Audio devices and select the index card Audio.
Depending on the PC configuration you must select
under Sound recording the standard device
MPC70USB or USB-Audio device for the MPC 70 USB.
• Then select the Volume button. For the microphone
you must move the volume control to the desired
position.
Important!
If you disconnect the MPC 70 USB and then
connnect it again, the volume control can shift
out of position. Therefore check the volume
control whenever you disconnect and reconnect
the microphone.
• As the MPC 70 USB is a mono microphone, the
balance control cannot be shifted.
12
All manuals and user guides at all-guides.com
®
XP, the microphone is
Use with the steno-s Software
If you use the MPC 70 USB with the steno-s recording
software, you must select some settings in the steno-s
program:
• Select in the recording window under Options /
General settings the index card Recording para-
meters and select MPC70USB for your microphone
under Selection recording device.
Troubleshooting
The microphone is switched on, the red LED is illumi-
nated, but there is no data transmission.
• Check if the USB plug has been connected to the
microphone correctly.
The recording volume is lower as set before.
• If you disconnect and reconnect the microphone, the
volume control can shift. Therefore check under
Control Panel / Sounds and Audio Devices / Audio
if the volume control for the microphone is still at the
selected position under Sound Recording / Volume.
Service
Servicing must be carried out by qualified service personnel
only. Dismantling the microphone yourself will invalidate
the guarantee.
Version
Model
Description . . . . . . . . . . . . . . . Order #
MPC 70 USB black, with connecting cable
type A/B, 3 m long,
with USB plug . . . . . . . . . . . . . 475.548
13
Publicité
Table des Matières
