Installation; Unpack Range; Install Anti-Tip Bracket - Whirlpool W11426601B Manuel D'utilisation

INSTALLATION

Unpack Range

WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
1. Remove shipping materials, tape and film from the range.
Keep cardboard bottom under range.
2. Remove oven racks and parts package from inside oven.
3. To place range on its back, take 4 cardboard corners from the
carton. Stack one cardboard corner on top of another. Repeat
with the other 2 corners. Place them lengthwise on the floor
behind the range to support the range when it is laid on its
back.
4. Using 2 or more people, firmly grasp the range and gently lay
it on its back on the cardboard corners.
5. Pull cardboard bottom firmly to remove.
6. Use an adjustable wrench to loosen the leveling legs.
7. Place cardboard or hardboard in front of range. Using 2 or
more people, stand range back up onto cardboard or
hardboard.

Install Anti-Tip Bracket

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
1. Remove the anti-tip bracket that is taped inside the upper
oven with the package containing literature.
2. Determine which mounting method to use: floor or wall. If you
have a stone or masonry floor, you can use the wall mounting
method.
12
3. Determine and mark edge of range in the cutout space. The
mounting bracket can be installed on either the left side or
right side of the cutout. Position mounting bracket in cutout so
that right (or left) edge of the bracket is 15/16" (2.4 cm) from
the marked edge of the range, as shown.
A. Anti-tip bracket
B. Mark edge of range
C. 15/16" (2.4 cm)
4.
Drill two 1/8" (3.0 mm) holes that correspond to the bracket holes of
the determined mounting method. See the following illustrations.
Floor Mounting
A. #12 x 1 5 / " screws
8
B. Anti-tip bracket
5.
Using the two #12 x 1 5 / " (4.1 cm) Phillips-head screws provided,
8
mount anti-tip bracket to the wall or floor.
Wall Mounting
A. #12 x 1 5 / " screws
8
B. Anti-tip bracket