Marque Verte BP 3BQ1-3 Mode D'emploi page 44

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

HI
The pressure in the cuff is too high (over 300 mmHg) OR the pulse is too high (over
200 beats per minute). Relax for 5 minutes and repeat the measurement.*
LO
The pulse is too low (less than 40 beats per minute). Repeat the measurement.*
* Please consult your doctor, if this or any other problem occurs repeatedly.
Other possible malfunctions and their elimination
If problems occur when using the device, the following points should be checked and if necessary,
the corresponding measures are to be taken:
Malfunction
The display remains empty when the
instrument is switched on although the
batteries are in place.
The device frequently fails to measure
the blood pressure values, or the values
measured are too low (too high).
Every measurement results in different
values although the device functions nor-
mally and the values displayed are normal.
The blood pressure values measured differ
from those measured by the doctor.
☞ Further Information
The level of blood-pressure is subject to fluctuations even with healthy people. Important thereby is,
that comparable measurements always require the same conditions (Quiet conditions)!
If, in spite of observing all these factors, the fluctuations are larger than 15mmHg, and/or you
hear irregular pulse tones on several occasions, please consult your doctor. You must consult
your specialist dealer or chemist if there are technical problems with the blood-pressure
instrument. Never attempt to repair the instrument yourself! Any unauthorised opening of the
instrument invalidates all guarantee claims!
Remedy
1. Check whether the batteries are installed with
the correct polarity and correct if necessary.
2. If the display is unusual, re-insert batteries or
exchange them.
1. Check the positioning of the cuff.
2. Measure the blood pressure again in complete
peace and quiet under observance of the details
made under point 5.
• Please read the following information and the
points listed under «Common sources of error».
Repeat the measurement.
• Record the daily development of the values and
consult your doctor about them.
40

Publicité

Table des Matières
loading

Table des Matières