Preparing Your Baby Monitor; Default Settings - VTech Crystal Sounds Mode D'emploi

Preparing Your Baby Monitor

Default Settings

The first time you turn on the parent and baby units, they are
operating with default settings. Adjustments can be made. Please see
corresponding sections in this manual for instructions.
Speaker volume setting (baby and parent unit)....page 15
Default: level 3 (out of 5 levels)
Sensitivity setting (parent unit)....page 15
Default: level 3 (out of 5 levels)
Power
The baby unit can be connected to a power source or powered by
batteries. Even if the baby unit is connected to a power source, we
recommend also inserting batteries. This guarantees automatic
backup in case of a power outage.
Technical Specifications:
• Baby Unit
- 1 x AC power adaptor 6V DC 500mA (included)
-  x AA (AM-3/LR6) 1.5V alkaline batteries (NOT
included)
• Parent Unit
- 1 x AC power adaptor DC 6V 300mA (included)
- 2 x AAA (AM-/LR03) 1.2V 750mAh Ni-MH
rechargeable batteries (included)
Operation:
Baby Unit
•
Adaptor operation
Put the large appliance plug into the baby unit's
socket, and then plug the adaptor into a wall
socket. The power-on light will glow. The baby
unit is ready for use.
10
6V DC 500mA
6V DC 300mA