Special Accessories; Installation; Unpacking; Placement - Electrolux EFS 633.1 Manuel D'utilisation

Special accessories

Active carbon filter
When the hood is used in recirculation mode an
active carbon filter should be used.

Installation

Unpacking

Check that the cooker hood has no damages.
Transportation damages should immediately be
reported to the one responsible for the transport
Damages, faults and eventually missing details
should immediately be reported to the seller.
Take care of the packing material so that small
children cannot play with it.

Placement

The hood is to be mounted to a wall cabinet.
When installed, the hood must be not less than 65
cm. above electric burners or 75 cm. above gas or
mixed-fuel burners. (Fig. 5).

Electrical connection

The hood has a power cord with moulded plug
with earth connection to be connected to a wall
outlet of 230 V.
The power cord length is 1,4 m.

Fastening the removable drawer

Fasten the removable drawer N using the six
2.9x16 screws U supplied in the accessory kit
(Fig. 6).
Remove the door to simplify this operation.

Mounting of hood to wall cabinet

● Drill on the bottom of the cabinet as indicated
on the drilling scheme (Do not consider the
thickness of the front door of the cabinet when
positioning the scheme).
● In vented exhaust hoods, make a Ø130-135 mm
hole both on the bottom and top of the cupboard
for the discharge pipe.
● From inside the cupboard, insert the four 4.2x35
screws M supplied in the accessory kit (Fig.7)
and screw them to the top of the hood.
● If the cupboard is deeper than the hood , fit the
spacer P and fix it on the back side of the hood
with two screws T and washers (Fig. 7)
The spacer is reversible to cover a gap of 1÷4 cm.
Order by the retailer
PNC 942 122 093
Fig. 5
U
N
U
Fig. 6
Fig. 7
29
Min
Min
75 cm
65 cm
U
U
U
U