Install The Hood - Broan B30 Serie Mode D'emploi

7" ROUND
DUCT
PLATE
12 DUCTED INSTALLATION ONLY:
Attach 3¼" x 10" Damper/Duct Connector (if using
3¼" x 10" duct) or 7" Round Duct Plate (if using 7-inch
round duct) over the knockout opening.
NOTE To accomodate off-center ductwork, the 3¼" x 10"
damper/duct connector can be installed up to ½" on
either side of the hood center and the 7" round duct
plate can be installed up to ½" on either side of the
hood center.
Trim the flange on the duct connector or duct plate if it
interferes with the electrical cable clamp.

INSTALL THE HOOD

WARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
13 Remove Electrical Wiring Box Cover from inside of hood.
3¼" X 10"
DAMPER /
DUCT
CONNECTOR
ELECTRICAL WIRING
BOX COVER
MODELS B3030SS • B3036SS
ELECTRICAL
POWER
CABLE
KNOCKOUT
14 Remove appropriate Electrical Power Cable Knockout
from top or back of hood.
HOUSE
POWER CABLE
15 Run House Power Cable between service panel
and hood location. Attach power cable to hood using
appropriate clamp.
16 Hang hood from (4) mounting screws driven part-way into
cabinet locations (shown in illustrations under "PREPARE
HOOD LOCATION"). Mounting screws are included in
parts bag. Slide hood back towards wall until mounting
screw heads are engaged in narrow end of keyhole slots
in top of hood. Tighten screws securely.
17 DUCTED INSTALLATION ONLY:
Connect ductwork to hood and use duct tape to make
joints secure and air-tight. Make sure the damper / duct
connector enters the ductwork and that the damper
opens and closes freely.
Page 5