jbc DR Mode D'emploi page 5

Placement instruction of the spiral in the tin
deposit
The spiral needs to be positioned between the
2 lines marked on the tin deposit.
Spiral
Solder tin deposits
It can be chosen between two different deposit
types:
- Metal Ref. 0812630.
- Glass Ref. 0812620.
C h a n g e t h e h e a t i n g e l e m e n t o f t h e
desoldering iron (Ref. DSV-DR)
- To perform this operation, the deposit
lid needs to be loosened.
Lid
Fixing screw
Heating element
DSV-DR
- Undo the screw indicated in the picture
and remove the heating element.
- Place the new heating element.
Alignment
Important.
- For a good connection it is essential to insert
the cartridge lining up the mark
handle screw cap.
Fixing screw
- Tighten the screw indicated in the picture
then tighten the lid.
JBC reserves the right to make technical changes without prior
notification.
4
ENGLISH
with the
Lid