Weston Realtree Outfitters 07-4101-RT Mode D'emploi page 6

All manuals and user guides at all-guides.com
Blade Assembly into the
4. Insert the
Lower Housing, guiding the Drive Shaft
into the journals. Make sure the gears
and the blades of the Blade Assembly
are properly meshed together and resting
in the journals (Figure D). NOTE: The
Tenderizer Blade is a 2-piece set. The
Jerky Slicer Blade is a single piece.
5. Position the Top Housing onto the
Lower Housing and line up the screw
holes.
6. Secure the Top
the Lower Housing
Housing Thumbscrews.
OVERTIGHTEN! (Figure E).
7. Insert the Left Comb and Right Comb
into the Top Housing (Figure E).
NOTE: The Left Comb is marked with an
"L" on the upper portion of the Comb. The
Top Housing is marked with an "L Comb"
and "R Comb" to aid in Comb installation.
8. Install Handle onto the Blade Drive
Shaft. Secure the Handle to Drive Shaft
with the Handle Thumbscrew (Figure F).
9. To change Blades, follow "Assembly
Instructions" 4-8 as outlined.
NOTE:
Periodically the gears on the
Blades need to be tightened. Use the
Allen Wrench to tighten the screw on the
gears.
Gears
Gears
Journals
Housing to
using the 2
DO NOT
Jerky blades and
Cuber/Tenderizer Blades
sold separately
-6-
Top
Housing
Lower
Housing
Housing
Thumbscrews (2)
Figure D
Blade
Assembly
Drive Shaft
Journals
Figure E
Figure F
Drive Shaft
Handle
Thumbscrew
Handle