CAME bpt MTMA/01 Manuel De Programmation page 15

N
Reprogramming
Reprogramming a system which has already been programmed, you access the call programming phase directly. To access button repro-
gramming, follow the process for forcing the mode switch described above.
If you add, replace or remove an entry panel, you must follow the "programming buttons" procedure so that the system recognises the
changes.
RESTORE FACTORY DEFAULT
To restore the entry panel to the default settings (including the terminal functions
the two call buttons on the unit and power the device.
After 5 seconds the entry panel restarts.
NOTE. If the entry panel does not restart, it has not been restored to default settings.
This product complies with the relevant directives in force.
Decommissioning and disposal. Dispose of the packaging and the device at the end of its life cycle responsibly, in compliance with
the laws in force in the country where the product is used. The recyclable components are marked with a symbol and the material's
ID marker.
THE DATA AND INFORMATION SHOWN IN THIS MANUAL ARE TO BE CONSIDERED AS SUBJECT TO CHANGE AT ANY TIME AND WITHOUT THE NEED
FOR ANY ADVANCE WARNING.
MEASUREMENTS, UNLESS OTHERWISE INDICATED, ARE IN MILLIMETRES.
Adjusting the brightness level of the light on the entry panel
While programming calls M a the brightness level of the entry panel can be adjusted
from any receiver. Pressing the "self-connection
b activates the video camera on the entry panel for which the brightness level is to be
adjusted. Use a previously assigned call button to increase/decrease the brightness of
the light N.
" button on the internal receiver M
and ), remove the power supply, press and hold