Replacing Hepa Filter; Removing And Installing Lower Plate - Dustbane Quiet Serie Manuel De Pièces Et D'opérations

NOTE: When the cleaning of the filter no longer restores vacuum cleaner suction to full power, replace the filter.
DO NOT operate without secondary filter installed.
DO NOT wash in the dishwasher.
DO NOT install the filter when damp. Ensure filter is fully inserted under plastic rib projections.

Replacing HEPA Filter

Removing and Installing Lower Plate

12 12
• Check filter when installing a new dust bag.
• Remove dust cover.
• Press tab on dust cover to release front cover.
• If dirty, replace filter.
• Place new filter into the dust cover.
• Ensure foam edge of the filter is facing towards the vacuum cleaner when placing
filter into dust cover.
• Ensure filter is fully inserted.
• Filters cannot be cleaned and should be replaced at least once each year.
• Reinstall front cover.
• Reinstall dust cover.
• Before servicing any parts, disconnect vacuum cleaner from electrical outlet.
• Always place paper under nozzle whenever lower plate is removed to protect floor.
• Place body in upright position and turn vacuum cleaner over to expose lower plate.
• Release lower plate by rotating the lower plate latches to the UNLOCK position.
• Remove lower plate and remove any residue that may exist in belt area.
• Reinstall lower plate by hooking front end of lower plate into slots on front of nozzle.
• Press lower plate onto nozzle and secure by rotating the lower plate latches to the
LOCK position.
WARNING Electrical Shock or Personal Injury Hazard
Disconnect the electrical supply before servicing or cleaning the vacuum
cleaner. Failure to do so could result in electrical shock or personal injury
from vacuum cleaner suddenly starting.