Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Motor Protector
Thermal Protector
• If a clog prevents the normal flow of air to the motor, the thermal protector turns the motor off automatically to allow the motor
to cool in order to prevent possible damage to the vacuum cleaner.
• To correct problem, turn off and unplug vacuum cleaner, remove clogs, and/or clean/replace filters.
• Replace full bag if necessary.
• Wait approximately fifty (50) minutes, plug vacuum cleaner in, and turn on to see if thermal protector has reset. Thermal
protector will not reset if vacuum cleaner is not turned off even if vacuum cleaner cools down.
Routine Care of Vacuum Cleaner
Performing the following tasks will keep your new vacuum cleaner operating at peak performance levels and will ensure these high
levels for years to come. Check the BEFORE REQUESTING SERVICE section in this manual for recommendations on performing some
of these tasks to help solve various problems that may occur.
Replacing Dust Bag
10
10
The motor protector automatically opens to provide cooling air to the motor when a
clog occurs or when dust bag needs changing. Motor protector may open when using
tools. If motor protector opens, the vacuum will make a slightly different sound.
NOTE: Do not block motor protector.
• Grasp top of dust cover and squeeze latch to release.
• Pull outward to remove dust cover.
• Remove dust bag by grasping cardboard portion and pulling out.
Publicité
Table des Matières
