Connecting To A Macintosh Computer - Sony SDM-HS75 Mode D'emploi

Setup
Before using your monitor, check that the following items are
included in your carton:
• LCD display
• Power cord
• HD15-HD15 video signal cable (analog RGB)
• Cord strap
• CD-ROM (utility software for Windows/Macintosh, Operating
Instructions, etc.)
• Warranty card
• Quick Setup Guide
Step 1: Open the stand
Note
The stand is folded at the factory. Be sure not to place the display
vertically with the stand as it is. Otherwise, the display may topple over.
Step 2: Connect the display to your
computer
Turn off the monitor and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this might
bend the pins.
• Check the alignment of the HD15 connector to prevent bending the pins
of the video signal cable connector.
Connect a computer equipped with an HD15
output connector (analog RGB)
Using the supplied HD15-HD15 video signal cable (analog RGB),
connect the computer to the monitor's HD15 input connector (analog
RGB).
Connect the computer according to the following illustrations.
x Connecting to an IBM PC/AT or compatible
computer
to the computer's HD15
output connector
(analog RGB)
IBM PC/AT or
compatible computer
x Connecting to a Macintosh computer
When connecting this monitor to a Macintosh computer, use the
Macintosh adapter (not supplied) if necessary. Connect the
Macintosh adapter to the computer before connecting the cable.
to the computer's
output connector
Macintosh computer
to the HD15
input connector
(analog RGB)
HD15-HD15 video signal
cable (analog RGB)
(supplied)
GB
to the HD15
input connector
(analog RGB)
HD15-HD15 video
signal cable (analog
RGB) (supplied)
7