Setup 2 Connecting Your Display To Your Computer - Sony SDM-V72W Mode D'emploi

Connecting your display to your computer
Setup 2
Turn off the display and computer before connecting. Do not touch the pins of the video signal cable connector as this might bend the pins.
1
Connecting to an IBM PC/AT
2
Connecting a Macintosh
- 10 -
1 Remove the back panel by holding top
with one hand as in the illustration then
snap out the buttons located at each
corner.
2 Remove the cable cover by lightly pulling
top concave portion.
Connecting to an IBM PC/AT or compatible
computer
Using the HD15/D-sub cable (supplied),
connect the computer to the display's HD15
input connector.
Be sure to check the alignment of the HD15/
D-sub cable. Do not force the connector in
the wrong way or the pins might bend.
Connecting a Macintosh
When connecting a Macintosh computer,
use an adapter (not supplied) if necessary.
Connect the adapter to the computer before
connecting the video signal cable.