Starting Operation; Machine Operation - Jet JWBS-10 Mode D'emploi

Before initial operation, the machine must be connected to a
dust extractor. The suction should switch on automatically
when the bandsaw is switched on.
The flow rate on the suction port must be 20m/sec.
Flexible hoses must be of non-flammable quality, and must
be connected to the machine ground system.

5.4 Starting operation

Magnetic(On/Off) Switch – located on front of machine:
You can start the machine with the green on button. The
red button on the main switch stops the machine.
Work Lamp Switch – located on front of machine above
On/Off switch. Turns LED work lamp on and off.

6. Machine operation

Correct working position:
In front of the machine standing in the direction of cutting.
Workpiece handling:
Hands placed flat on the workpiece outside the cutting area.
Feed the workpiece towards the saw blade in the direction of
the saw line, and cut as required by turning to follow the line
drawn. Push the workpiece steadily forward; complete the
cut as a single movement. Do not draw the workpiece back,
as this could cause the sawblade to run off its wheels.
Support long and wide workpieces with helping roller stands.
Operating hints:
Work only with a sharp and flawless sawblade.
Near the cutting area use a push stick to feed.
Use a feeding template to safely guide small and narrow
workpieces.
Use a suitable wedge to prevent round timber from turning
under the pressure of the cut
Workpiece setup:
Bring the upper blade guide to a distance of approx 2-5mm
to the workpiece. (See Fig 17).
For your own safety, always set the saw guide as close to
the workpiece as possible.
Fig. 17
To adjust the cutting height release the winged nut (A, Fig
18) and move the upper blade guide and guard assembly
(B).
Blade Drift Compensation:
Blade drift is a frequent problem on rip cuts and during
resawing.
Blade drift may occur when the fence is being used, the
blade begins to wander off the cutting line (Fig. 19).
Blade drift can be caused by a number of factors.
- The saw blade follows the grain
- The saw blade is dull.
- Blade guides not adjusted correctly.
- Blade tension unsufficient.
- Blade-teeth have asymmetric"set"
Auxiliary fence for rip fence:
For your own safety always set the upper saw guide as
close to the workpiece as possible.
For narrow shallow cuts on the rip fence a self-made
auxiliary fence (E, Fig. 20) made of cutable material ( e.g.
wood, plastic, aluminium) must be used.
Length same as rip fence.
10
Fig. 18
Fig. 19