Transport And Installation; Assembly - Jet JWBS-10 Mode D'emploi

Hardware package (JWBS10-HP), includes:
3 Hex cap screw, M8x55 – HP1
4 Hex washer head screw, M6x12 – HP2
32 Carriage bolt, M6x12 – HP3
4 Wing screw – HP4
4 Flat washer blk oxide M8 – HP5
6 Flat washer M8 – HP6
3 Lock washer M8 – HP7
3 Hex nut, M8 – HP8
32 Hex flange nut, M6 – HP9
5. Transport and start up

5.1 Transport and installation

For transport use a forklift or hand trolley. Make sure the
machine does not tip or fall off during transport.
The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
Stability of bandsaw.
Before using the bandsaw, ensure the machines upright
stability is satisfactory.
The bandsaw has three Ø8mm holes (A, Fig 5 Fig.6 Fig.7)
in it's base to allow it to be bolted to a workbench or to the
supplied open stand
Fig. 4
Fig. 5
For packing reasons the machine is not completely
assembled.
Refer to Figure 6,Figure 7 to assemble stand. Use carriage
bolts (HP3) and flange nuts (HP9) throughout. Only hand-
tighten all fasteners at this time.
Make sure the two short support plates with extra holes (M)
are opposite one another as shown.
Slip rubber feet (L) onto ends of stand legs.
Place stand upright on level floor, and push down until it sits
evenly.
Tighten all nuts on stand assembly.

5.2 Assembly

If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly
manner.
Clean all rust protected surfaces with a mild solvent.
Prior to use, the following items have to be fitted:
Bandsaw table, Rip fence guide and Crank handle.
Fig.6
Fig. 7