Zipper Maschinen ZI-MOS4TA Manuel D'utilisation page 28

15 TROUBLE SHOOTING
Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
Trouble
Engine does not start
Engine starts and is stalled
immediately
Machine works with
interruptions
Machine does not work with
full performance
Blade rotates at idling
Blade rotates but has no
power
Bad cuts
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MOS4TA
W A R N I N G
Possible cause
 Incorrect starting sequence
 Dirty air filter
 No fuel supply
 Fault in the fuel line
 Engine flooded.
 Spark plug connector not
placed on.
 No ignition spark
 Incorrect idle adjustment
 Carburetor incorrectly
adjusted
 Spark plug fouled
 Machine overloaded
 Dirty air filter
 Carburetor incorrectly
adjusted
 Idle speed too high
 Choke is ON
 Foreign material wrapped,
grass around the sheet
 Long grass
 Blunt saw blade
NOTICE
INHALT / INDEX / INDICE/
Solution
 Observe the correct starting
sequence
 Clean/replace air filter
 Refuel
 Check the fuel line for kinks or
damages
 Screw off, clean and dry the spark
plug. Then pull the cranking rope
several times and reinstall the spark
plug
 Place on the spark plug connector
 Clean/replace spark plug
 Check ignition cable
 Contact customer service
 Contact customer service
 Clean/replace spark plug
 Check spark plug connector
 Too much pressure
 Cutting material too tough
 Clean/replace air filter
 Contact customer service
 Adjust a lower idle speed
 Set Choke to OFF
 Shut machine off, wait until cutter
stands still, remove the winded up
material
 Remove material
 Sharpen or replace saw blade
28