Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11
SAFETY
11.1 Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the assembly
instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
Mowing and trimming grass at moderate and non-slippery terrain and for cutting twigs and hedges.
Any manipulation of the machine or its parts is a misuse, in this case
and its sales partners cannot be made liable for ANY direct or indirect damage.
Do not change the mowing attachment!
Using saw blades for the machine is prohibited!
Damaged cutting tools may be not straightened or welded in no case
11.2 Safety instructions
Missing or non-readable security stickers have to be replaced immediately!
To avoid malfunction, machine defects and injuries, read the following security
instructions!
The locally applicable laws and regulations may specify the minimum age of the operator and limit
the use of this machine!
Use the machine only in good enough light to allow a safe operation can be guaranteed.
In tiredness, decreased concentration or under the influence of alcohol or drugs, the work on
the machine is prohibited!
Caution in slippery conditions - slip hazard - risk of injury. When working, robust and non-slip
footwear. Slides / stumble / traps are a major cause of serious injury or death.
The machine may only be operated by trained personnel.
Unauthorized persons, especially children and not trained personnel must be kept away from the
running machine!
If you pass the machine to third, these instructions must be attached to the machine.
Before each use, the reliability of the machine is to be checked (tightness of the cutting tool, the
proper function of the throttle lever)
Danger of burns! During the operation flow of hot exhaust gases and engine parts such as the
carburettor and engine become hot.
Never place a hot brush cutter in dry grass or other easily flammable materials.
After the operation, the machine must cool down. Otherwise there is an imminent risk of burns
WARNING: Gasoline is highly flammable!
Smoking and open flames are prohibited during refuelling. Do not refuel when the engine and
carburettor are still very hot.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-MOS4TA
WARNING
HIGHEST RISK OF INJURY!
INHALT / INDEX / INDICE/
ZIPPER-MASCHINEN
19
Publicité
Table des Matières
