Fust NOVAMATIC FH66-412K Notice D'utilisation page 16

All manuals and user guides at all-guides.com
16
Levelling
The appliance is provided with adjustable
small feet placed in the back and front cor-
ners of the base.
By adjusting the small feet it is possible to
change the height of the appliance so as to
ensure a better levelling with other surfaces
and an even distribution of the liquids con-
tained in pots and pans.
Electrical connections
Warning! Any electrical work required
to install this hob and the supply cable
should be carried out by a qualified
electrician or competent person, in
accordance with the current regulations.
This cooker is designed to be connected to
a 230/400 V, 50 Hz electrical supply. To con-
nect to the electricity supply, use cable type
H05 RR-F.
Before switching on, make sure the electricity
supply voltage is the same as that indicated
on the rating plate.
The cooker is not supplied with a supply ca-
ble. A flexible supply cable must be fitted, in
accordance with the specification given in
the relevant table no. 1.
In case of a direct connection to the mains,
you have to interpose an omnipolar switch
with a minimum opening between contacts
of 3 mm must be done under over voltage
category III condition.
The switch should be sited within 2 m of the
hob and be easily accessible upon comple-
tion of the installation.
The yellow-green grounding cable must not
be interrupted by the switch.
Important! NOTE: The earth wire should be
about 2 cm longer than the live and neutral
wires.