On-Screen Messages - Sony SDM-S75A Mode D'emploi

Moniteur couleur tft lcd
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 53
Troubleshooting
Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 18.
If "OUT OF RANGE" appears on the screen
This indicates that the input signal is not supported by the
display's specifications. Check the following items.
For more information about on-screen messages, see "Trouble
symptoms and remedies" on page 18.
If "xxx.x kHz/xxx Hz" is displayed
This indicates that either the horizontal or vertical frequency
is not supported by the display's specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
Example
I NFORMA T I ON
OUT OF RANGE
I NPUT 1 DV I - D
:
x x x . x k H z /
If "RESOLUTION > 1280 × 1024" is displayed
This indicates that the resolution is not supported by the
display's specifications (1280 × 1024 or less).
Example
I NFORMA T I ON
OUT OF RANGE
I NPUT 1 : DV I - D
RESOL UT I ON >
x x x H z
1 8 0 X 1
2
0
2
4
If "NO INPUT SIGNAL" appears on the screen
This indicates that no signal is being input via the currently
selected connector.
When INPUT SENSING (page 15) is set to ON, the display finds
another input signal and changes the input automatically.
Example
I NFORMA T I ON
NO I NPUT S I GNA L
I NPUT 1 DV I - D
GO TO POWER SAVE
When input signals cannot be found
"GO TO POWER SAVE" message appears.
5 seconds later, the power saving mode starts.
If "CABLE DISCONNECTED" appears on the
screen
This indicates that the video signal cable has been disconnected
from the currently selected connector.
When INPUT SENSING (page 15) is set to ON, the display finds
another input signal and changes the input automatically.
Example
I NFORMA T I ON
CAB L E D I SCONNECT ED
I NPUT 1 DV I - D
GO TO POWER SAVE
When input signals cannot be found
"GO TO POWER SAVE" message appears.
45 seconds later, the power saving mode starts.
17
:
:
GB

Publicité

Table des Matières
loading

Table des Matières