Fault/Error Codes & Troubleshooting Steps - Jenn-Air JDRP436HM Mode D'emploi

FOR SERVICE TECHNICIAN'S USE ONLY
The fault codes below may be indicated under various conditions and can be accessed through Service Diagnostics.
Fault codes are displayed by alternately showing F# and E#. All fault codes have an F# and an E#. The F# indicates the suspect System/Category. The E#
indicates the suspect Component system.
Display EXPLANATION AND RECOMMENDED PROCEDURE
F1E0 Check User Interface Board - EEPROM Communication Error
The user interface board(s) is locked up due to an unexpected internal communication error. This is often corrected by cycling power.
Possible Causes: Software/EEPROM or Internal UI Board memory chip failure.
Recommended Procedure: See TEST #4 (User Interface Input Voltage and Communication) on page 20.
F1E1 Control Relay Board - EEPROM Communication Error
Immediately after the Oven control sees an unexpected event.
Possible Causes: There may be a problem with the oven control(s) or the associated wiring.
Recommended Procedure: See TEST #1 and #2 (Main Control (ACU)) on page 17 and 18.
F2E1 Stuck Key - Button Functionality Error
Start button or Light Button has lost function.
Possible Causes: A keypad has been pressed for an extended period of time.
The result of the user pressing a keypad for too long.
Recommended Procedure: See TEST #12 (Start or Light Button) on page 30.
F2E2
Oven Knob - Rotary Encoder Open/Shorted
Problem with the user interface board(s) - Rotary Encoder Open/Shorted.
Possible causes: Rotary Encoder Open/Shorted. Can occur within 120 seconds of rotary encoder open/shorted.
Recommended Procedure: See TEST #13 (Knob) on page 31.
Fault/Error Codes & Troubleshooting Steps
12