Jenn-Air JDRP436HM Mode D'emploi page 10

FOR SERVICE TECHNICIAN'S USE ONLY
Errors stored in the memory will be displayed from the most recent
■
occurrence to the oldest.
The Fault (F) Wi-Fi LED turns ON and the knob LEDs flash the
■
corresponding number (#). Then the UI is blank for a half second before
displaying the Error (#) code.
There is a 1 second delay between each fault/error code (F# E#).
■
Errors will continue to be displayed until the mode is exited or the mode
■
times out.
If there are no additional errors in the memory (OR if there are no errors
■
at all), the speaker will tone 3 times and the first error will be displayed
again.
NOTE: If the error (E) number is zero ("0"), then only the fault (F) number is
displayed for that code.
To clear: After review, the stored error codes can be cleared out or erased. To
clear all error codes, press the Start button once.
10