KitchenAid KUIS18PNZB Guide D'utilisation Et D'entretien page 13

Condenser
A Dirty or Clogged Condenser
Obstructs proper airflow.
■
Reduces ice making capacity.
■
Causes higher than recommended operating temperatures
■
which may lead to component failure.
WARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug ice maker or disconnect power.
2. Remove the 2 screws in the lower access panel and the
2 screws from the base grille area of the front panel support.
3. Pull the bottom forward and then pull down to remove the
lower access panel.
A
B
A. Lower access panel screws
B. Base grille screws
4. Remove dirt and lint from the condenser fins and the unit
compartment with a brush attachment on a vacuum cleaner.
A. Condenser fins
5. Replace the lower access panel using the 4 screws.
6. Plug in ice maker or reconnect power.
Interior Components
1. Unplug ice maker or disconnect power.
2. Open the storage bin door and remove any ice that is in the
bin.
3. Remove the drain cap from the water pan and drain
thoroughly. Replace the drain cap securely on the water pan.
If the drain cap is loose, water will empty from the water pan,
and you will have either thin ice or no ice.
4. Remove the screw from the cutter grid cover.
5. Unplug the wiring harness from the left side of the cutter grid.
6. Unplug the ice level sensor from the right side of the cutter
grid. Pull the ice level sensor down and forward away from the
cutter grid.
7. Remove the right-hand and left-hand screws. Lift the cutter
grid up and out.
NOTE: Make sure the plastic spacer from the right-hand side
of the cutter grid bracket stays with the cutter grid.
A
8. Remove the mounting screw that holds the water pan in
place. Pull out on the front of the water pan.
B
9. Disconnect the pump bracket from the water pan and unplug
the water pan drain pump.
A
10. Remove, clean and replace the ice scoop and ice scoop
holder.
NOTE: On some models, the ice scoop holder is located in the
upper left of the unit, and on other models, the ice scoop holder is
located in the lower left of the unit.
B
A. Cutter grid cover
B. Screw
A
B
C
A. Cutter grid harness
D. Ice level sensor harness
B. Screw
E. Plastic spacer
C. Cutter grid
F. Screw
A. Water pan C. Drain cap
B. Water pan screw D. Drain pump cover
A
D
E
F
A
B
D
C
13