Endress+Hauser Micropilot NMR81 Manuel De Mise En Service page 164

Menu de configuration
Modbus address
Navigation
Prérequis
Description
Entrée
Réglage usine
Information
supplémentaire
Float swap mode
Navigation
Prérequis
Description
Sélection
Réglage usine
Information
supplémentaire
Bus termination
Navigation
Prérequis
Description
Sélection
164
 Setup → Advanced setup → Communication → Modbus X1-4 → Configuration
→ Device ID
Communication interface protocol (→  162) = MODBUS
Defines the Modbus address of the device.
1 ... 247
1
Accès en lecture
Accès en écriture
 Setup → Advanced setup → Communication → Modbus X1-4 → Configuration
→ Float swap mode
Communication interface protocol (→  162) = MODBUS
Sets the format of how the floating point value is transfered on Modbus.
• Normal 3-2-1-0
• Swap 0-1-2-3
• WW Swap 1-0-3-2
Swap 0-1-2-3
Accès en lecture
Accès en écriture
 Setup → Advanced setup → Communication → Modbus X1-4 → Configuration → Bus
termination
Communication interface protocol (→  162) = MODBUS
Activates or deactivates the bus termination at the device. Should only be activated on the
last device in a loop.
• Off
• On
Operator
Maintenance
Operator
Maintenance
Micropilot NMR81



Endress+Hauser