Deletion Of Id; Important - Panasonic WX-CH455 Mode D'emploi

Setting the unit
w Deletion of ID
p
When the Center Module is WX-C3010, delete the ID of this product according to the
following procedure.
This setting is enabled when the Center Module model selection setting is set to
WX-C3010.
When WX-CC411, WX-CC411A, WX-CC412 or WX-CC412A is set, there is no need to
delete the ID manually. Delete the ID on the Center Module.
1
Rotate the microphone boom to turn off the power of this product.
2
For deleting an ID registered in the Center Module of Lane A
Rotate the microphone boom while holding down the [VOL] and [T] buttons to
turn on the power of this product.
p ● The unit starts in "Delete ID mode". The power indicator blinks orange.
For deleting an ID registered in the Center Module of Lane B
Rotate the microphone boom while holding down the [VOL] and [P] buttons to
turn on the power of this product.
p ● The unit starts in "Delete ID mode". The power indicator blinks orange.
3
Press the [P] button.
p ● The ID is deleted instantly, the voice message "ID not registered" is heard from the
earphone, and the power indicator blinks red to indicate an abnormal state.
p ● If Deletion of ID fails, an error beep and the voice message "Failed" are heard from
the earphone, and the power indicator blinks red to indicate an abnormal state. If
that happens, retry from step 1.

Important

p p When the number of ID registrations of the headset and (or) the Belt Pack exceeds
the Center Module's upper limit, the Center Module deletes some IDs automatically.
If a unit of the headset and (or) the Belt Pack is not used for an extended time after
being registered, its ID may be deleted.
32
WX-CH455_PGQX2221ZAC1.indb 32
All manuals and user guides at all-guides.com
2017/08/21 16:11:10