Descale - Teuco SAUNA J Manuel D'utilisation

RUNNING THE DESCALE CYCLE
The need to carry out a chemical scale removal is signalled by the dial of the "
" , button switching on a high intensity and at the same time, with the low intensity
lighting up of the dial on the
In any case, it is possible to have three more sauna cycles before the sauna
system locks down; if this occurs, the scale removal signal will remain, the dial on
" "
the button will be switched off and the boiler tank will not be able to operate .
To activate the descale function, proceed as follows:
SAUNA J
GB DESCALE
" "
button .
- Press the " " button and hold for 8 seconds to start the
descale cycle .
- The reception of the command is confirmed by three
flashes of the coloured ring nut positioned around the "
key . At this point, the light becomes fixed again for a
variable period of between 30 seconds and 2 minutes .
Following an interval of between 30 seconds and two
minutes, the luminous ring around the descale button will
start to blink .
The light on the "
intensity and frequency (2 flashes per second) .
" button will start to flash at high
GB
"
9