Teuco SAUNA J Manuel D'utilisation page 10

GB
AT THIS MOMENT, IT IS NECESSARY TO POUR THE
SCALE REMOVER LIQUID INTO THE FILLER CAP.
Prepare the solution as shown on the scale remover liquid .
Pour the scale remover in the special tray until the circuit is
completely full (according to the sauna version, the scale
remover required will vary from 500cc to 800cc) .
The start of the scale removal process is shown by a
reduction in the flashing frequency of the " " button (1 flash
every two seconds) .
Remember to replace the cap of the decalcifier's topping up
tube .
The scale removal process takes about two hours and for all
this time, the dial on the " " button will continue to flash at
low frequency .
The cycle should be run preferably during night hours, or at
least when the sauna is not in use .
The cabin can still be used with the shower or multifunctions
while the descaling cycle is running .
At the end of the descaling phase, the descale luminous ring
turns off, and only the luminous ring around the sauna
button remains lit . The sauna can now be used again .
SAUNA J
10