Klarstein TAFELSPITZ Mode D'emploi page 18

EN
18
ASSEMBLY
Hardware
(N1) Screw (x4)
(N2) Washer, Nut and
Screw (2 sets)
Remove the frame and accessories from
their packaging. Place the frame holders
(Z1) on the curved tube and fasten them
to the tube with two screws (N1). Slide
the wheel axle (a) through the two holes
located at the ends of the tubes.
(N3) Screw (x3)
(C) R Pin (x2)
Attach the wheels (b) to both sides of
the axle (a).
(N3) Washer and Nut
(x3)
(S1) Butterfly Screw
(x1)