Roco 95 Serie Manuel page 46

6 Medium speed (at medium running step) - Value 1 corresponds to 1/3 of Vmax. (CV 5)
7 Decoder Version Number (only read! Readable only on reading-capable amplifiers/centres).
Important! Please note when using the MULTIMAUS® in order to achieve CVs greater than CV255: when
undertaking a short-term programming of CV7, only the subsequent programming access with the value 10 is
increased by 100 CV places (meaning CV166 then accesses CV266 for example). The value 20 is increased
by 200 CV places.
8 Resetting of all values to the default settings; (With readable amplifiers/controllers, the manufacturer ID is readable)
13 Analogue modes F1 - F8 (00 – no function in analogue mode)
01 – Function F1
16 – Function F5
Attention! Several things happen at the same time when several functions are activated via CV's in analogue operation.
14 Analogue modes F9 - F12
01 – Locomotive headlight (front) | 02 – Locomotive headlight (rear) | 04 – Function F9
08 – Function F10 | 16 – Function F11 | 32 – Function F12
17+ Long address (requirement: corresponding CV29 long address setting is activated)
18
29 Settings
266 Total Volume of all Sounds
267
A higher value in CV267 results in a lower number of hammers per wheel revolution and a lower value results in a higher
number. The value should be in the range of 120-135.
46
02 – Function F2 04 – Function F3
32 – Function F6 64 – Function F7
08 – Function F4
128 – Function F8
00 – 252 1
08 = Reset
00 – 255 1
00 – 255 195
100 – 9999
14
00 – 255 80
128