Maintenance And Repair Instructions; Accessories/Replacement Parts; Specifications - Cub Cadet CCBT Manuel

CLEANING
Use a small brush to clean off the outside of the unit. Do not
use strong detergents. Household cleaners that contain
aromatic oils such as pine and lemon, and solvents such as
kerosene, can damage plastic housing or handle. Wipe off any
moisture with a soft cloth. Also keep the air vents free of
obstructions.
STORAGE
• Allow the unit to cool before storing.
• Lock the unit to prevent unauthorized use or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
To Use the Hanger
To use the hanger, make sure that the attachment is removed from
the unit.
1. Place the hanger on the end of the attachment and slide
down until it touches the release button (Fig. 10).
2. Press the release button and hold it in.
3. Slide the hanger over the depressed release button.
4. Adjust the hanger so that the release button clicks into the
any of the holes in the hanger.
CUTTING ATTACHMENT WILL NOT CUT
C A U S E
Cutting attachment bound with grass
Cutting attachment line is broken or too short
Shift lever is in blower mode
NOTE: For repairs beyond the minor adjustments listed above, call 1-877-282-8684 if in the United States or 1-800-668-1238 if in
Canada to obtain a list of qualified service dealers.
DRIVE SHAFT AND CUTTING HEAD
Drive Shaft............................................................................................................................................................................................Steel
Unit Weight.................................................................................................................................................................4 lbs. 15 oz. (2.24 kg)
Cutting Mechanism .......................................................................................................................................................... Fixed Line Head
Line Type................................................................................................................................................. .105 inch (2.667 mm) Spiral Line
Cutting Swath ...................................................................................................................................................................16 inches (40.64 mm)
MAINTENANCE & REPAIR INSTRUCTIONS
TROUBLESHOOTING
Stop the unit and clean cutting attachment
Refill with new line
Move the shift lever to trim mode

SPECIFICATIONS

Hanger
Holes
Release
Button
TRANSPORTING
• Allow the unit to cool before transporting.
• Secure the unit while transporting.

ACCESSORIES/REPLACEMENT PARTS

Replacement line can be purchased from Cub Cadet dealers:
.105-inch Spiral Line . . . . . . . . . . . . . . . . . . . . . .49UFSHLK953
A C T I O N
Fig. 10
7