JVC GR-DV1 Manuel page 55

All manuals and user guides at all-guides.com
POWER DIAL
REMOTE SENSOR
FADER/WIPE BUTTON
EFFECT BUTTON
EDIT IN/OUT BUTTON
4 SET EDIT-IN POINT
At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit In
position appears in the viewfinder and on the
connected TV.
5
SET EDIT-OUT POINT
At the end of the scene, press EDIT IN/OUT.
The Edit Out position appears in the viewfinder
and on the connected TV.
6 USE FADE WIPE ON SCENE
TRANSITION
Press FADE/WIPE.
•Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
•If you select a Fade//Wipe effect for an
Edit-Out point, the effect is automatically
applied to the following Edit-In point.
•When you use Fade/Wipe effects, that time is
included in the total time (this does not apply
to Picture Wipe/Dissolve).
7 USE P.AE/EFFECT
Press EFFECT.
•Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
•You can use Classic Film, Monotone, Sepia,
Strobe or Video Echo effects.
8 CONTINUE EDITING
Repeat steps 4 – 7.
•If you're not using Fade/Wipe or P.AE/Effects,
repeat steps 4 and 5 only.
1
2
3
4
5
6
7
RM-V708U (provided)
8
T I ME CODE
TOTAL
T W
PLAY BUTTON
R.A.EDIT ON/OFF BUTTON
CANCEL BUTTON
NOTES:
When choosing a scene, set Edit-In and Edit-Out
points so there's a relatively large difference
between them.
If the search time for an in-point exceeds
5 minutes, the recording deck's Record-Standby
mode will be cancelled and editing will not take
place.
If there are blank portions before or after the
Edit-In and Edit-Out points, a blue-backed screen
may be included in the edited version.
Since time codes register time only as accurately
as seconds, the time code total time may not
match the total program time exactly.
Turning off the camcorder's power erases all
registered Edit-In and Edit-Out points.
To use a P. AE/Effect, press EFFECT on the remote
control repeatedly to cycle through the effects
until the one you want is displayed.
To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
If you use Sepia or Monotone P.AE/Effects, you
can't use the Dissolve or Black & White Fader. In
this case the Dissolve or Black & White indicator
begins blinking. Once the next Edit-In point is
registered, the effect is turned off. To combine
these effects, use Sepia or Monotone during
recording, then use Dissolve or Black & White
Fader during Random Assemble Editing.
55
PROGRAM
I N OUT
: ~ :
~
~
~
~
~
~
~
:
00 : 00
RANDOM ASSEMBLE
EDITING MENU
CONTINUED ON NEXT PAGE